Rolls-Royce Corniche - Electrically Operated Window Lift Motor in Position; Heater Blowers Switch-To Remove; Hazard Warning Switch-To Remove; Radio Receiver-To Remove

Rolls-Royce Silver Shadow B Bentley T Series
Workshop Manual
Chapter M
5. Remove the window lift master switch
embellisher in the same manner as described in
Operation 3.
6. Remove the remote control handle.
7.
Remove the emergency window winder
embellisher by unscrewing the two securing screws.
8.
Lift off the door arm rest.
9. Remove the two screws securing the arm rest
mounting plate.
10. Remove the three screws securing the door
garnish rail.
1 1.
Lifting vertically, remove the door garnish rail.
12.
Remove the door trim pad by placing the hands
at the centre of the upper and lower edges of the
door trim pad. Exert pressure at these points
causing the trim pad to
' bell-out'.
This operation releases the door trim pad from
the two stainless steel retainers at the leading and
trailing edges of the door; remove the dust cover.
13. Remove the setscrews securing the drop
window to the
pick-up plate.
14.
Remove the
screws securing the chainguard
to the inner door panel.
15. Disconnect the electrical connections from the
terminal
box situated on the face of the motor
assembly, noting the positions to facilitate fitting.
16. Remove the two setscrews securing the
electric window lift motor to the base of the door.
17. Remove the window lift motor.
Heater blowers switch-To remove
Cars prior to Car Serial Number 6000
Proceed as described in Section M9 - Interior
switches.
Heater blowers switch-To remove
Cars from Car Serial Number 6000
1. Disconilect the battery.
2.
Remove the centre console wooden finisher by
removing the four screws.
3.
Roll back
the floor covering from the centre
console.
4. Remove the eight screws securing the console
to the floor.
5.
Place the console on its side and disconnect
the electrical connections; lift out the console.
6. Place the console on a clean working surface;
remove the screws securing the switch to the
console.
7.
Turn the switch through 90' and withdraw from
the rear of the console.
Hazard warning switch-To remove
Cars prior to Car Serial Number 6000
Proceed as described in Section M9 - Interior
switches.
Hazard warning switch-To remove
Cars from Car Seria! Number 6000
1. Disconnect the battery.
2.
Remove the hazard warning switch knob, by
unscrewing in an anti-clockwise direction.
3. Remove the bulb.
4.
Remove the ashtray by lifting vertically.
5.
Remove the switch circular securing nut and
withdraw the switch downwards and out through the
ashtray aperture.
Radio receiver-To remove
,Cars prior to Car Serial Number 6000
Proceed as described in Section M15 Radio
Receivers and Loudspeakers.
FIG. MI00 ELECTRICALLY OPERATED WINDOW
LIFT MOTOR IN POSITION
A Lower mounts (hidden)
1 Upper mounts
2 Chain guard
3 Motor
4 Connector block
5 Emergency winder mechanism