OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-77
[300] CUSTOMER ON/OFF PER STATION
Allows the following features to be enabled/disabled on a per-station basis.
No Option Default Description
00 ACCESS DIAL ON Determines whether a user can select a trunk or trunk
group by dialing its Directory Number (DN). This selection
should be turned off when using LCR.
01 MICROPHONE ON Allows phones to be used in speakerphone mode.
02 OFF-HOOK RING ON Will allow a short burst of ring tone to indicate another call.
03 SMDR PRINT ON When the station is set for no Trunk Line calls to and from
this station, the station will not print on SMDR. This
includes transferred calls or calls picked up from hold or
park.
04 TGR ADV.TONE ON When this feature is set to ON, a warning tone will be
heard each time LCR advances to the next route.
05 VMAA FORWARD ON This feature selects whether Trunk Line calls can be
forwarded to voice mail: ON, permits forward to voice
mail; OFF, no forward to voice mail.
07 NGT PASSCODE ON When ON, the steps verifying the ring plan passcode will
be added in Ring Plan change.
08 INTRCOM SMDR OFF When the station is set to OFF, the station will not print
intercom calls on SMDR.
09 FWD DELAY USE OFF When ON, calls will overflow to the Forward No Answer
destination when the Forward No Answer timer expires
even when the Forward No Answer feature is not
activated at the called party extension.
11 FORWARD OVRD OFF When set to ON and the station calls another station
which has forwarding set, the call will not forward.
12 RECL TO OPER OFF When the station is set to ON, if the station transfers a call
and the destination doesn’t answer, the call will recall to
the operator instead of the station.
13 SLT LP OPEN OFF When ON, SLI port receives real disconnect signal
instead of busy or error tone. (VMAA or DATA ports
always receive real disconnect signal.)
14 NO COST PRINT OFF When ON, if replacing the handset of a regular phone when no
digit is pressed after hook flash, recall is carried out.
15 CID TO SLT OFF When a MIS card is installed and this option is set to ON,
the system will provide the CID signal to SLTs.
22 NO RCL FLASH OFF When the hook switch is flashed or the flash key is
pressed, a recall signal will not be sent to the system.
To Next Page
Loading...
