CHAPTER 2. MMC Programming
2-404
© SAMSUNG Electronics Co., Ltd.
[845] WLAN PARAMETERS
This MMC modifies the WLAN parameters.
WLAN PARAMETER
No Parameter Description Default
01 CODEC LIST CODEC that can be used for VoIP calls between
WBS24 and terminal. G.711u, G.711a, G.726, and
G.729 can all be assigned.
CODEC 1: G.729
CODEC 2: NONE
CODEC 3: NONE
CODEC 4: NONE
02 RF CHANNEL Set a RF CHANNEL value that can be used by
WBS.
USE CH 1: 01
USE CH 2: 06
USE CH 3: 11
USE CH 4: 00
USE CH 5: 00
USE CH 6: 00
07 VERSION WLAN module version. Version
20 MAX AP CH. Set the maximum channel number of AP
If AP type is not Commercial AP, this option can be
shown.
00
21 WLAN SWTCH Support WLAN switch function
In case that AP type is not WBS COMBO, this
option can be shown
DISABLE
SIP PARAMETER
No Parameter Description Default (ms)
0 RE-TRANS T1 When using an unreliable transmission protocol
such as UDP, retransmission is required when no
reply is received. RE-TRANS.T1 TIME is the initial
retransmission interval defined in RFC2543.
500
1 RE-TRANS T2 Maximum retransmission interval defined in RFC
2543
4000
2 RE-TRANS T4 RFC 2543 defines this parameter for various
purposes. For example, this parameter can be used
as the time waited by User Agent Server after
receiving ACK message in an unreliable
transmission protocol.
5000
3 GEN RING TM When using an unreliable transmission protocol, the
server cannot be sure if the client has received the
last reply. Thus, the server must retransmit the reply
for this length of time until it receives the requested
retransmission. For example, this parameter can be
used as the waiting time after sending 200 OK for
INFO.
6000
To Next Page
Loading...
