Samsung OfficeServ 7000 Series - Network Dial Translation

CHAPTER 2. MMC Programming
2-348
© SAMSUNG Electronics Co., Ltd.
[824] NETWORK DIAL TRANSLATION
Assigns the digit translation table used for networking. Generally, under networking
conditions, you must dial the node ID and extension number to call the another node
extension. In this MMC, the system provides a simple digit translation so that the user need
only dial the extension number to call the station on the other node. The access digit needs
to be programmed in MMC 724 (‘LCR-01’ parameter in NETWORK NUMBER option)
first. The system allows 96 entries for network dial translation.
DEFAULT DATA
NONE
ACTION DISPLAY
1) Press Transfer button and enter 824.
Display shows:
01:601 
SIZE:0 MAX:00
2) Dial the entry number.
OR
01:601  _
SIZE:0 MAX:00
Press Volume button to select and press Right Soft
button to move cursor.
3) Enter digit string for access to node (max. 8 digits)
and press Right Soft button to move cursor.
01:601  60201
SIZE:0 MAX:00
4) Enter number of digits user will dial. (e.g., 3 for 3-
digit extension)
01:601  60201
SIZE:3 MAX:00
OR
Press Volume button to select and press Right Soft
button to move cursor.
5) Enter max. number of digits system will dial.
OR
01:601 (60201
SIZE:3 MAX:08
Press Volume button to select and press Right Soft
button to move cursor.
6) Enter YES/NO to display other node extension in
internal extension number format.
01:601 (60201
DISP:N MBX:N
OR
Press Volume button to select and press Right Soft
button to move cursor.