Samsung OfficeServ 7000 Series - Assign Tenant Group

CHAPTER 2. MMC Programming
2-320
© SAMSUNG Electronics Co., Ltd.
[803] ASSIGN TENANT GROUP
Allows the assignment of tenant groups on a per-cabinet, slot and port basis. The simple
rule is Cabinet-Slot-Port = Tenant. The simplicity of this program allows for flexible
assignments. The only information needed is the correct correlation of entries.
DEFAULT DATA
ALL ASSIGNMENTS: TENANT 1
ACTION DISPLAY
1) Press Transfer button and enter 803.
Display shows:
TENANT GROUP
C:1 S:1 -01 T:1
2) Enter cabinet number. (if no change press Right Soft
button to move cursor.)
TENANT GROUP
C:1 S:1 –01 T:1
3) Enter slot number. (if no change press Right Soft
button to move cursor.)
TENANT GROUP
C:1 S:2 -01 T:1
4) Enter port number. (if no change press Right Soft
button to move cursor.)
TENANT GROUP
C:1 S:2 -03 T:1
5) Enter tenant number. (if no change press Right Soft
button to return to step 2)
TENANT GROUP
C:1 S:2 -03 T:2
6) Press Transfer button to save and exit.
OR
Press Speaker button to advance to next MMC.
RELATED ITEMS
NONE