CHAPTER 2. MMC Programming
2-358
© SAMSUNG Electronics Co., Ltd.
[830] LAN PARAMETERS
This MMC provides a mean to configure the Internet Protocol (IP) addressing of the MCP
card.
No Parameter Description
00 SYSTEM IP ADDR Specifies the IP address for the MCP card.
01 SYSTEM GATEWAY Specifies the designated gateway IP address used for contacting
IP devices beyond the local network subnet.
02 SYSTEM NET MASK Specifies the IP subnet mask.
This parameter is used by the system to calculate the range of IP
devices (subnet) that are within ‘direct reach’ of the MCP. (without
having to go through the designated network IP gateway)
03 SYSTEM RESET Prompt to reset system MCP when system IP address is changed.
This reset is same as FAST RESTART in MMC 811.
04 SYSTEM IP TYPE Specifies if the system will be routing data over a public or private
network.
05 SYS PUBLIC IP1 The MCP will originate communications to IP phones and VoIP
connections outside the local network using this IP address.
Communications to/from this IP will require involvement of the MGI
card. The system identifies communications to/from this address
as ‘public’. This allows devices, on remote networks/subnets, to
establish communications with the system, without exposing the
LAN. See ‘SYSTEM IP TYPE’.
06 SYS PUBLIC IP2 The MCP will originate communications to IP phones and VoIP
connections outside the local network using this IP address.
Communications to/from this IP will require involvement of the MGI
card. The system identifies communications to/from this address
as ‘public’. This allows devices, on remote networks/subnets, to
establish communications with the system, without exposing the
LAN. See ‘SYSTEM IP TYPE’.
07 SYS PUBLIC IP3 The MCP will originate communications to IP phones and VoIP
connections outside the local network using this IP address.
Communications to/from this IP will require involvement of the MGI
card. The system identifies communications to/from this address
as ‘public’. This allows devices, on remote networks/subnets, to
establish communications with the system, without exposing the
LAN. See ‘SYSTEM IP TYPE’.
08 SYSTEM MAC ADDR For reference, and cannot be changed. The unique hardware
(MAC) address of the MCP card.
09 SYSTEM IP VERS Specify the system IP address is IPv4/Ipv6
(This option may not be available in certain OfficeServ models.)
13 DATA SERVER IP IP address of Data Server
(This option may not be available in certain OfficeServ models.)
To Next Page
Loading...
