Samsung OfficeServ 7000 Series - Tx Level and Gain

CHAPTER 2. MMC Programming
2-324
© SAMSUNG Electronics Co., Ltd.
[805] TX LEVEL AND GAIN
Allows the system administrator to set the base level of TX volume on phones. There are
eight levels that can be controlled by the Volume buttons on phones, and 10 controllable
levels in the system. This MMC allows the system administrator to classify any desired
eight levels within 11.
No Option Description
0 TX LEVEL CONTROL Adjusts the transmitting sensitivity (max.: 9) Default values are:
INDEX: 0 1 2 3 4 5 6 7
LEVEL: 0 1 2 4 3 5 6 7
1 MISC TSW GAIN Adjusts the level of the internal music source of the MCP card or
the external music source of the MIS card (0~7, higher numbers
mean lower levels). Default value is 0.
(This option may not be available in certain OfficeServ models.)
2 TSW GAIN
CONTROL
Adjusts the tone sensitivity. There are 11 types of matrix
connections of the T-Switch that adjust the tone sensitivity.
If the gain value of each trunk channel is configured in MMC421,
this option is ignored.
3 CID TYPE/LEVEL Adjusts the CID type and TX/RX Gain
- TYPE: CID TYPE control. (BELLCORE/ETSI)
- RX LEVEL: TX gain control (0 – 20)
- TX LEVEL: RX gain control (-6 – 0)
- DOWNLOAD: download adjusted CID TYPE and TX/
TX gain to SP
When changing the MMC [805]
‘MMC [805] TX LEVEL AND GAIN’ should not be changed from the default levels
without the assistance of the local SAMSUNG distributor.
DEFAULT DATA
SOME OPTIONS DEPEND ON COUNTRY
ACTION DISPLAY
1) Press Transfer button and enter 805.
Display shows:
TX LEVEL CONTROL
LEVEL 0  0
2) Press Volume button to make selection (0-3) and
press Right Soft button to move cursor.
TX LEVEL CONTROL
LEVEL 1  1