CHAPTER 2. MMC Programming
2-366
© SAMSUNG Electronics Co., Ltd.
[833] VoIP IP TABLE
This MMC provides the IP addresses in tables pointed to by the VoIP code entry (MMC
832). There are 251 tables with up to 4 entries each. The destination IP address is required
to route dialed digits based on the access code and digits dialed. The IP entry field is
divided into 4 sections allowing modification of separate IP address fields.
When changing IP
When changing any IP address/value, listed below, three digits must be input for
each (octet) field. Example 192.168.1.10 input must be: 192 168 001 010
No Option Description
0 ENTRY 1 This indicates the first entry of each destination IP address table.
1 ENTRY 2 This indicates the second entry of each destination IP address table.
2 ENTRY 3 This indicates the third entry of each destination IP address table.
3 ENTRY 4 This indicates the fourth entry of each destination IP address table.
4 PROTOCOL
Default value is SIP. Set PROTOCOL to H323 when the table is used for
H323 signaling.
6 ALIVE CHK Set ALIVE CHK to OPTION when the link test is required. When set,
system sends OPTIONS message to the destination SIP Server.
7 USER INFO Alphanumeric System username of To and From header in OPTIONS
message. When empty, system does not send OPTIONS message to
the Destination SIP Server.
8 RMT PORT Sets the port to use on the SIP Server.
9 CHK TIMER When ALIVE CHK is set, CHK TIMER decides the message sending
10 ALIVE STS ENTRY1 AVAIL: YES
11 SIG TYPE This indicates the transport type in SIP message Signaling. SIP
message can be transported either using UDP or TCP.
(This option may not be available in certain OfficeServ models.)
DEFAULT DATA
TB (000) ENTRY (00): MMC 830 SYSTEM IP ADDR
PROTOCOL: SIP
ALIVE CHK: NONE
RMT PORT: 5060
CHK TIMER: 1800
ALIV STS: All ENTRY AVAIL are YES
SIG TYPE: UDP
ALL OTHERS: EMPTY
To Next Page
Loading...
