Samsung OfficeServ 7000 Series - Halt Processing

CHAPTER 2. MMC Programming
2-330
© SAMSUNG Electronics Co., Ltd.
[810] HALT PROCESSING
Used only in the event that all data processing needs to be stopped either in a single cabinet
slot or in the entire system.
DEFAULT DATA
PROC
ACTION DISPLAY
1) Press Transfer button and enter 810.
Display shows:
HALT/PROCESSING
C:ALL S:ALL  PROC
2) Enter cabinet selection via dial keypad.
OR
HALT/PROCESSING
C:1 S:ALL  PROC
Press Volume button to make selection and press
Right Soft button to advance cursor.
OR
Select all cabinets and slots. (and go to step 4)
HALT/PROCESSING
C:ALL S:ALL  PROC
3) Enter slot number via dial keypad.
OR
HALT/PROCESSING
C:1 S:2  PROC
Press Volume button to make selection and press
Right Soft button to advance cursor.
4) Enter 1 for HALT or 0 for PROC.
OR
Press Volume button to make selection and press
Right Soft button to enter and return to step 2.
5) Press Transfer button to save and exit.
OR
Press Speaker button to advance to next MMC.
RELATED ITEMS
NONE