Samsung OfficeServ 7000 Series - System Options

CHAPTER 2. MMC Programming
2-432
© SAMSUNG Electronics Co., Ltd.
[861] SYSTEM OPTIONS
Sets a number of system options.
No Option Description
0 AUTO UPDATE TIME Sets enable (1) or disable (0) the system automatically time and
date update from ISDN call connection message. If sets enable,
when system receives ISDN call connection message, system
checks valid data of encapsulated time and date, and update
system time and date device.
1 SYSTEM SPPED BIN Sets max 500 (0) or max 950 (1) for the maximum number of
system speed dial bin.
2 IDLE WHEN ENBLOC Decides the state of Large LCD Phone treated as idle or busy
when the user of Large LCD Phone is dialing in ENBLOCK
mode.
3 2 LINE ENBLOCK Decides the usage of ENBLOCK mode for 2 line LCD Phone with
navigation buttons.
4 2 ZONE EXT PAGE Decides whether 2 Zone external paging is enabled or not.
(This option may not be available in certain OfficeServ models.)
5 USE LB FOR PAGE Decides whether LB port of MISC card is used as ROP port or
not. (This option may not be available in certain OfficeServ
models.)
6 LP TRK TONE DISC When this option is set to ON, loop trunk can be disconnected by
detecting busy tone.
7 SPNET OVERLAP Designate whether to operate as the OVERLAP Mode in case of
SPNET Dialing.
8 SPNET CLI TABLE This is the option to display the designated CLI number instead
of the (NODE + extension number) in the CLIP table of the
MMC323 when the network call is received in the KB net.
9 E-LCR CLI TABLE This is the option to comply with the clip table in case of the E-
LCR Call.
10 EXTERNAL BGM/MOH Background music source can use internal source or external
source. In case of external source, music source can be
supported in MISC port. (This option may not be available in
certain OfficeServ models.)
11 LCP CABINET TYPE The OfficeServ 7200 can also use the OfficeServ 7100 as a
expansion cabinet. This option can be shown in the OfficeServ
7200.
0: OS7200 CABINET
1: OS7100 CABINET
12 MAX CHAIN FWDALL If ALL CALL FORWARD or BUSY FORWARD is set, it is
possible to designate how many hops can be supported.