Samsung OfficeServ 7000 Series - Assign Trunk Signal

CHAPTER 2. MMC Programming
2-130
© SAMSUNG Electronics Co., Ltd.
[412] ASSIGN TRUNK SIGNAL
Allows the assignment of analogue DID or E&M cards for proper Signaling.
These trunks can also use the translation tables in MMC 714.
No Signaling condition type
0 IMMEDIATE START
1 DELAYED START
2 WINK START
3 NO ANSWER BACK
4 DIRECT BACK
CONDITIONS
An analogue E&M/DID Trunk card must be installed in the OfficeServ 7000 Series system.
Or, the ‘NO E&M/DID TRUNK’ message is displayed.
DEFAULT DATA
IMMEDIATE START
ACTION DISPLAY
1)
Press Transfer button and enter 412.
Display shows:
[701] TRK SIGNAL
IMMEDIATE START
2)
Enter desired trunk number. (e.g., 705)
OR
[705] TRK SIGNAL
IMMEDIATE START
Press Volume button to make selection and press
Right Soft button to move cursor.
OR
Select all trunks.
[ALL] TRK SIGNAL
IMMEDIATE START
3)
Enter desired trunk type selection from above list.
OR
[705] TRK SIGNAL
WINK START
Press Volume butto
n to make selection and press
Right Soft button.
4)
Press Transfer button to save and exit.
OR
Press Speaker button to advance to next MMC.
RELATED ITEMS
MMC 416 ASSIGN E & M/DID RINGDOWN
MMC 714 DID NUMBER AND NAME TRANSLATION