CHAPTER 2. MMC Programming
2-36
© SAMSUNG Electronics Co., Ltd.
[119] CALLER ID DISPLAY
Allows the technician to set the individual station display preference on a per-station basis.
Caller ID or CLI (Command Line Interface), DDI can be selected to either show the name,
number first, or no display depending on the type of call. Caller ID or CLI, DDI displays
have the following options:
No Type Description
0 RING LINE1 When incoming call is ringing, the specific information is displayed in the
upper line of the phone display.
NO DISPLAY Display trunk number only.
And any information will not be displayed in the
lower line of the phone display.
CLI NUMBER FIRST According to priority, it displays CLI number or
CLI name or trunk number. If the former is not
valid, the latter has a priority.
CLI NAME FIRST According to priority, it displays CLI name or CLI
number or trunk number. If the former is not
valid, the latter has a priority.
DDI NUMBER FIRST According to priority, it displays DDI number or
DDI name. If the former is not valid, the latter has
a priority. If both are invalid, it operates as a CLI
NAME FIRST.
DDI NAME FIRST According to priority, it displays DDI name or DDI
number. If the former is not valid, the latter has a
priority. If both are invalid, it operates as a CLI
NAME FIRST.
GROUP NAME
FIRST
In case of group call, it displays ‘Call <group
name>’ or ‘Call For 5000’. If not group call, it
operates as a CLI NAME FIRST.
DDI NUMBER/NAME It displays ‘DDI NUMBER/DDI NAME’. It only
supports up to 16 characters. If both are invalid,
it operates as a CLI NAME FIRST.
DDI NAME/NUMBER It displays ‘DDI NAME/DDI NUMBER’. It only
supports up to 16 characters. If both are invalid,
it operates as a CLI NAME FIRST.
1 RING LINE2 When incoming call is ringing, the specific information is displayed in the
lower line of the phone display.
RING LINE2 has the same options as RING LINE1
To Next Page
Loading...
