Samsung OfficeServ 7000 Series - Toll Pass Code;Special Code Table

CHAPTER 2. MMC Programming
2-234
© SAMSUNG Electronics Co., Ltd.
[709] TOLL PASS CODE/SPECIAL CODE TABLE
This MMC provides a means to program trunk code tables as described below.
No Special Code Description
0 PBX ACCESS CODE This table contains up to five entries and is used to identify the
trunk access codes needed for toll restriction when the system
is used with either a PBX or a CENTREX-supplied dial tone.
Toll restriction will only be applied on trunks flagged as PBX in
MMC 401 if a trunk access code entered in this table is dialed.
Toll restriction will be applied to the digits following the trunk
access code.
1 SPECIAL CODE This table identifies the special feature codes used to activate
central office custom-calling features such as CID Block and
Call Waiting Disable. The special feature codes can be used on
a per-call basis without affecting LCR or toll restriction
programming. There is a maximum of 10 entries available, each
of which may be up to four digits long.
2 TOLL OVERRIDE This table of eight entries is used to identify the numbers that
will bypass all dialing restrictions. This bypass includes toll
restriction, trunk access and forced authorization or account
codes. Each entry in the table can be up to 14 digits long.
3 OVRD USE TRK GRP This entry designates the trunk group that toll override calls will
access.
DEFAULT DATA
NONE
ACTION DISPLAY
1)
Press Transfer button and enter 709.
Display shows:
PBX ACCESS CODE
1:
2) Select PBX, SPECIAL CODE, TOLL OVERRIDE
or OVRD USE TRK GRP.
TOLL OVERRIDE
1:
OR
Press Volume button to make selection and press
Right Soft button to move cursor.
3) Enter index number. (e.g., 3)
OR
TOLL OVERRIDE
3:_
Press Volume button to make selection and press
Right Soft button to move cursor.