Samsung OfficeServ 7000 Series - Crm Dsp Mode Select

OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-353
[827] CRM DSP MODE SELECT
This MMC can assign CRM DSP mode. CRM D-Board can be operated one mode of
DTMFR, R2MFC, CID.
OfficeServ 7400 allows to configure the mode per DSP in CRM D-Board.
On the other hand, OfficeServ7200 allows to configure the mode per CRM D-Board.
If there is not CRM Board in LP40 or MCP, MP20, displays ‘NO CRM’.
This option may not be available in certain OfficeServ models.
Type Option
OfficeServ7400 C:1-LOC:1-DSP:1
DTMFR  DTMFR
OfficeServ7200 CRM DSP MODE SET
C1-B1: DTMFR
CONDITION
CRM board must be equiped in LP40 or MPC, MP20.
DEFAULT DATA
DSP1: DTMFR, DSP2: DTMFR
ACTION DISPLAY
1) Press Transfer button and enter 827.
Display shows:
C:1-LOC:1-DSP:1
DTMFR  DTMFR
2) Dial the cabinet number. (1-3)
OR
C:1-LOC:1-DSP:1
DTMFR  DTMFR
Press Volume button to select and press Right Soft
button to move cursor.
3) Dial the LOC number. (1-2)
OR
C:1-LOC:1-DSP:1
DTMFR  DTMFR
Press Volume button to select and press Right Soft
button to move cursor.
4) Dial the DSP number. (1-2)
OR
C:1-LOC:1-DSP:1
DTMFR  DTMFR
Press Volume button to select and press Right Soft
button to move cursor.