OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-379
[837] SIP OPTIONS
This MMC permits the adjustments of optional Session Initiation Protocol (SIP) trunk
parameters. The MCP supports SIP and H.323 on a per-call-per-port basis. The settings are
system wide.
When changing IP
When changing any IP address/value, listed below, three digits must be input for
each (octet) field. Example 192.168.1.10 input must be: 192 168 001 010
SIP Stack Configuration
No Parameter Description Default
00 RE-TRANS.
T1
The initial re-transmission time if there is no answer,
based on the RFC2543 specification. The range is
0~9900 ms.
500 ms
01 RE-TRANS.
T2
The maximum re-transmission time if there is no answer,
based on the RFC2543 specification. The range is
0~9900 ms.
4000 ms
02 RE-TRANS.
T4
The time the User Agent Server waits after receiving the
ACK message. Based on the RFC2543 specification.
The range is 0~9900 ms.
5000 ms
03 GENERAL
RING
The server retransmits the response for this length of
time until the requested retransmission is received.
For example, the wait time after sending 200 OK for
INFO. The range is 0~99900 ms.
5000 ms
04 INVITE RING After the client sends ACK for the INVITE Final Response, the
client cannot confirm if the server received the ACK message.
The client waits for this length of time after sending ACK
for the Final Response. The range is 0~99900 ms.
5000 ms
05 PROVISIONAL
After receiving the Provision Response, the User Agent
waits for this length of time until Timeout ends. The range
is 0~999900 ms.
180000 m
06 INV NO RESP Before sending Cancel for the Invite Request, the User
Agent waits for this length of time. The range is 0~99900
ms.
5000 ms
07 GEN NO
RESP
Before sending Cancel for General Request, the User
Agent waits for this length of time. The range is 0~99900
5000 ms
08 REQ RETRY After sending General Request, the User Agent waits for
the Final Response for this length of time. The range is
0~99900 ms.
5000 ms
To Next Page
Loading...
