Samsung OfficeServ 7000 Series - Bri and Pri Card Restart

CHAPTER 2. MMC Programming
2-138
© SAMSUNG Electronics Co., Ltd.
[418] BRI AND PRI CARD RESTART
This MMC is used to restart a BRI (Basic Rate Interface) or PRI (Private Rate Interface)
card at the card level or a BRM at the module level. This action is required to update the
processor on the BRI (BRM) or PRI card with any changes in the card setup MMCs and to
put these changes into effect.
CONDITIONS
 A BRI card or BRM or TEPRI (T1E1 PRI) card or TEPRI2 card must be installed in
the system.
 Before setting the PRI program, the J2 jumper of the TEPRI or TEPRI2 card must be
set ON to PRI mode.
DEFAULT DATA
NONE
ACTION DISPLAY
1) Press Transfer button and enter 418.
Display shows first BRI or PRI circuit:
[725] RESTART
CARD RESTART?NO
2) Dial first trunk on a BRI or PRI card. (e.g., 733)
OR
[733] RESTART
CARD RESTART?NO
Press Volume button to select the first trunk and press
Right Soft button to move the cursor.
3) Dial 1 for YES or 0 for NO.
Pressing 1 will advance to step 4.
[733] RESTART
CARD RESTART?YES
4) Dial 1 for YES or 0 for NO.
Pressing 1 or 0 will return to step 2.
[733] RESTART
ARE YOU SURE?YES
5) Press Transfer button to save and exit.
OR
Press Speaker button to advance to next MMC.
RELATED ITEMS
MMC 419 BRI OPTIONS
MMC 420 PRI OPTIONS
MMC 423 S/T MODE
MMC 424 BRI S0 MAPPING