OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-113
[400] CUSTOMER ON/OFF PER TRUNK
Assigns several options (listed below) on a per-trunk basis.
No Option Default Description
0 1A2 EMULATION OFF When this option is set to ON up to 4 internal stations
can participate in a conversation on this trunk by
pressing the trunk key.
1 TRUNK INC DND OFF When this option is set to ON a trunk that is
programmed to ring a specific station (a private line or
DIL) will ring at that station if the station is in DND.
2 TRUNK FORWARD ON When this option is set to OFF this trunk will not follow a
ringing stations call forwarding.
3 LCR ALLOW OFF Allows LCR to be switched ON/OFF when a trunk is
accessed using a DT key or by dialing its port number
(e.g., 701).
4 MOH/BGM USE OFF When this option is set to ON, MOH feature for
8TRK/8TRK2/16TRK/4TRM card is enabled.
6 EFWD EXT CLI ON This option determines what kinds of CLI number will be
sent to the external forwarded outgoing call. (Station or
Received CLI from Trunk)
7 REPEAT CLI ON This option determines what kinds of CLI number will be
sent to the trunk to trunk call. (Trunk or Received CLI
from Trunk)
8 TONECHK DISC OFF When this option is set to ON, loop trunk can be discon-
nected by detecting busy tone. (To use this feature, the
LP TRK TONE DISC option in MMC 861 must be set to
ENABLE.)
9 AUTO ANSWER OFF When this option is set to ON, Auto Answer mode can
be assigned on a per-trunk basis.
10 COLORING AS OFF To provide coloring, and not ring back tone, a channel
should be connected when a trunk line call is received.
For a trunk line call that no channel is connected, this
option determines if the coloring service is provided by
sending the ANSBACK message.
12 TANDEM CLI ON When this option is set to ON, ‘0’ is attached in front of
the Caller ID received for a trunk line Tandem call.
To Next Page
Loading...
