Samsung OfficeServ 7000 Series - Msn Digit

CHAPTER 2. MMC Programming
2-148
© SAMSUNG Electronics Co., Ltd.
[421] MSN DIGIT
Provides a method of assigning an incoming MSN call to a specific station. If any entry in
the MSN DIGIT TABLE matches an incoming call’s called party number, either the
specific station is alerted, if it is programmed to accept the call, or the call is cleared if it is
programmed to reject the call.
If the incoming called party number does not have a matching entry in the MSN table,
MMC 406 ringing destination is alerted or the call is optionally released.
You can give each MSN number to a specific station and you can select the call waiting
option: when a destination is busy, the incoming call must be cleared or camped-on to the
station. (which is alerted to the call)
CONDITIONS
 A BRI card must be installed in the system. Or, the ‘NO BRI CARD’ message is
displayed.
 For each BRI access, two adjacent ports are assigned. You need only change the value
for one of the two ports; the value for the other port will be changed automatically.
DEFAULT DATA
1-6: NONE
CW: YES
OPT: ACCEPT
ACTION DISPLAY
1) Press Transfer button and enter 421.
Display shows:
[701] MSN DGT (1)
DGT:
2) Enter trunk number. (e.g., 704)
OR
[704] MSN DGT (1)
DGT:
Press Volume button to scroll through ISDN ports
and press Right Soft button to move cursor.
3) Enter the location 1-8. (e.g., 4)
OR
[704] MSN DGT (4)
DGT:
Press Volume button to select location and press
Right Soft button to move cursor.
4) Enter digits to be translated (e.g., 4603881) via dial
keypad and press Right Soft button to move to the
destination selection. (Max. Digit is 12)
[704] MSN DGT (4)
DGT:4603881