Samsung OfficeServ 7000 Series - Assign Trunk Group

OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-199
[603] ASSIGN TRUNK GROUP
Allows the assignment of trunks to a specific trunk group or to several trunk groups. This is
useful in the programming of LCR when more than one trunk is to be in several dialing
plans. There are two different modes of operation: (1) sequential and (2) distribute.
There are 30 programmable trunk groups with up to 99 members per group. But in case of
OfficeServ 7100, it is possible to assign up to 60 members per group and there are 11
programmable trunk groups.
Trunk group
One trunk can appear in more than one trunk group. If necessary, delete the trunk
member from other groups to prevent accidental access.
No Item Description
0 TYPE Specify the type of trunk group. This option has 7 kinds of values.
MIXED TRUNK: default. Associated in various kind of trunk channel
NORMAL TRK
ISDN TRK
SIP TRK
H.323 TRUNK
SPNET TRUNK
QSIG PRI
1 MODE Select the way searching idle channel of trunk.
2 MEMBER Trunk channel member
You can input trunk channel corresponding trunk type. But in case of
MIXED TRUNK type, It’s possible to input different kind of trunk
channel
DEFAULT DATA
Item Description
TYPE / MEMBER 9 MIXED TRUNK/LOOP, BRI, PRI trunk
800 MIXED TRUNK/E&M, B/W
801 ISDN TRUNK/ISDN trunk
803 SPNET TRUNK/VoIP Networking trunk
804 H.323 TRUNK/H.323 trunk
(H323 is not used in some OfficeServ
system.)
805 SIP TRUNK/SIP trunk
others
MIXED TRUNK/NONE
MODE SEQUENTIAL