Samsung OfficeServ 7000 Series - Page 238

CHAPTER 2. MMC Programming
2-200
© SAMSUNG Electronics Co., Ltd.
ACTION DISPLAY
1) Press Transfer button and enter 603.
Display shows:
[9] TRK GROUP
TYPE:MIXED TRUNK
2) Enter valid trunk group. (e.g., 9)
OR
[9] TRK GROUP
TYPE:MIXED TRUNK
Press Volume button to make selection and press
Right Soft button to advance cursor.
3) Press Right Soft button to change mode.
OR
[9] TRK GROUP
MODE: SEQUENTIAL
Press Volume button to change mode to member.
4) Press Right Soft button to change mode.
OR
[9] TRK GROUP
MEMBER 01:NONE
Press Volume button to change mode to member.
5) Press Right Soft button to move cursor to number of
member and enter valid member number
[9] TRK GROUP
MEMBER 05:NONE
(e.g., 05) via dial keypad.
OR
Press Volume button to make selection and press
Right Soft button to move cursor.
6) Enter valid trunk number. (e.g., 729)
OR
[9] TRK GROUP
MEMBER 01:729
Press Volume button to make selection and press
Right Soft button to return to step 2.
7) Repeat steps 1-5 to remove trunk from group 9 if
necessary.
8) Press Transfer button to save and exit.
OR
Press Speaker button to advance to next MMC.