Samsung OfficeServ 7000 Series - Assign System Speed Dial

CHAPTER 2. MMC Programming
2-228
© SAMSUNG Electronics Co., Ltd.
[705] ASSIGN SYSTEM SPEED DIAL
Enables the assignment of system speed dialing numbers. There are up to 500 entries
available for programming. (or 950 entries if set in MMC 861 SYSTEM OPTIONS) Each
speed dial number consists of a trunk or trunk group access code followed by a separator
and up to 24 digits to be dialed. These dialed digits may consist of 0-9, and #. If the system
recognizes a valid trunk or trunk group access number, it will automatically insert the
separator.
NOTE: If 500 entries are allowed, the bin numbers are 500-999; if 950 entries are allowed,
the bin numbers are 050-999.
DEFAULT DATA
NONE
PROGRAM BUTTONS
B Used to insert a flash code ‘F’
C Used to insert a pause code ‘P’
D Used to insert a pulse/tone conversion code ‘C’.
E Used to mask/unmask following digits-shows as ‘[’ or ‘]’
F Used to enter name for speed dial bin (see MMC 706)
ANS/RLS Used to save the speed dial number and name to the CID translation
table (MMC 728)
ACTION DISPLAY
1) Press Transfer button and enter 705.
Display shows:
SYS SPEED DIAL
500:
2) Dial speed index desired. (e.g., 505)
OR
SYS SPEED DIAL
505:
Press Volume button to make selection and press
Right Soft button to move cursor.
3) Enter access code (e.g., 9) plus the phone number up
to 24 digits (digits will scroll under)
SYS SPEED DIAL
505:9–121223456789
and press Right Soft button to return to step 2.
4) Press F key to toggle to MMC 706 step 3 to enter
name.
SYS SPEED NAME
505: