Samsung OfficeServ 7000 Series - Assign System Link ID

OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-341
[820] ASSIGN SYSTEM LINK ID
This MMC is used to assign the system link ID for PRI and VoIP networking. Up to 100
link IDs can be entered including SELF ID. In addition, each Link ID is associated with the
IP address.
Option Description
LINK ID System ID for networking feature.
SIGNAL G/W System IP address for VoIP networking.
TIME SYNC System Time and date can be updated by QSIG Call
NODE NAME System Node Name for VoIP networking
NO MGI No: Use MGI as of old, Yes: Don’t use MGI
(This option can be shown in case that MMC 861 ‘MPS SERVICE’ set to
ENABLE)
CODEC Preferentially used CODEC for SPNET
CONDITIONS
‘SELF’ represents self-node, and must be set to use the networking function. Items other
than ‘SELF’ are used for station numbers and can be omitted.
DEFAULT DATA
NONE
ACTION DISPLAY
1)
Press Transfer button and enter 820.
Display shows:
SELF:LINK ID
2) Enter SELF link ID via dial keypad and press Right
Soft button.
SELF:LINK ID
11
3)
Press Volume button to select other link ID and
press Right Soft button to mover cursor.
SYS01:LINK ID
4) Enter other link ID via dial keypad and press Right
Soft button.
SYS01:LINK ID
22
5) Press Transfer button to save and exit.
OR
Press Speaker button to advance to next MMC.