CHAPTER 2. MMC Programming
2-316
© SAMSUNG Electronics Co., Ltd.
[764] DISA PASSWORD
This is the program to enable the DISA incoming call without entering the DISA password
according to the CLI number of the incoming call to the DISA trunk line.
It is available to designate 500 CLI numbers, and if the DISA call is received to the CLI
number corresponding to the entered CLI number, it is available to make a call without
entering the password although the MMC210 DISA PSWD is designated as ON.
CONDITIONS
None
DEFAULT DATA
None
ACTION DISPLAY
1) Press the Transfer button and the 764.
DISA PASS (001)
CLI:
2) Enter the table number ([001]-[500]).
Otherwise, select the table number by the Volume
button.
Move the cursor by pressing the Right soft button.
DISA PASS (001)
CLI:
3) Enter the CLI number within maximum 16 digits,
and move the cursor by pressing the Right soft
DISA PASS (001)
CLI: 1234
4) Press the Transfer button to complete the procedure
or press the Speaker button to store the data.
RELATED ITEMS
Program 210 Designate the system On/Off.
Program 410 Extension DISA service
To Next Page
Loading...
