Samsung OfficeServ 7000 Series - Page 397

OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-359
(Continued)
No Parameter Description
14 IP-UMS SERVER Specify an IP UMS SERVER IP address.
(This option may not be available in certain OfficeServ models.)
15 IP-UMS PORT Specify an IP UMS SERVER port.
(This option may not be available in certain OfficeServ models.)
16 IP-IVR SERVER Specify an IP IVR SERVER IP address.
(This option may not be available in certain OfficeServ models.)
17 IP-IVR PORT Specify an IP IVR SERVER port.
(This option may not be available in certain OfficeServ models.)
18 MASTER/SLAVE IP Specify an Slave (extension Rack) IP address in OS7030.
(This option may not be available in certain OfficeServ models.)
19 MMS PORT IP address of NMS TRAP Server
(This option may not be available in certain OfficeServ models.)
21 NMS TRAP SERVER IP address of NMS TRAP Server
(This option may not be available in certain OfficeServ models.)
22 CTI SERVER ADDR IP address of CTI Server
25 NEWS ADDRESS IP address of News Server
26 EMAIL SERVER Specify an EMAIL SERVER IP address.
(This option may not be available in certain OfficeServ models.)
27 MMS SERVER ADDR Specify an MMS SERVER IP address.
(This option may not be available in certain OfficeServ models.)
28 MMS WEB SERVER Specify an MMS WEB SERVER IP address.
(This option may not be available in certain OfficeServ models.)
29 IMPS SERVER ADDR Specify an IMPS SER SERVER IP address.
(This option may not be available in certain OfficeServ models.)
30 QoS CHECK
SERVER
Specify a QoS CHECK SERVER IP address.
(This option may not be available in certain OfficeServ models.)
LAN PARAMETERS
- The first three parameters: SYSTEM IP ADDR, SYSTEM GATEWAY, and
SYSTEM NET MASK are stored separately from the main system database
and thus will not be defaulted when MMC811 ‘CLEAR MEMORY’ is performed.
Furthermore, any changes to these parameters will not be applied until the MP
card is reset.
- When changing any IP address/value, three digits must be entered for each
(octet) field. For example 192.168.1.10 should be entered as: 192 168 001 010.
CONDITIONS
 This MMC must be used if there are ITP phones and/or MGI cards on the system.
 After changing LAN parameters, restart the system to apply the new settings.