CHAPTER 2. MMC Programming
2-128
© SAMSUNG Electronics Co., Ltd.
CONDITIONS
An E1 card must be installed in the system, otherwise the message ‘NO E1 TRUNK
CARD’ is displayed.
DEFAULT DATA
NONE
ACTION DISPLAY
1)
Press Transfer button and enter 411.
Display shows:
[701] E1 SIGNAL
UNUSE
2)
Enter desired trunk number. (e.g., 705)
OR
[705] E1 SIGNAL
UNUSE
Press Volume button to make selection.
Press Right Soft button to move cursor.
OR
Select all trunks.
[ALL] E1 SIGNAL
?
3) Press Volume button to select trunk type and press
Right Soft button to move cursor.
[705] E1 SIGNAL
E&M:IMMEDIATE
4) Press Volume button to Signaling select and press
Right Soft button to move cursor.
[705] E1 SIGNAL
E&M:ITU_WINK
5) Press Transfer button to save and exit.
OR
Press Speaker button to advance to next MMC.
RELATED ITEMS
TRUNK PROGRAMMING
MMC 400 CUSTOMER ON/OFF PER TRUNK
MMC 401 TRUNK LINE/PBX LINE
MMC 402 TRUNK DIAL TYPE
MMC 403 TRUNK TOLL CLASS
MMC 404 TRUNK NAME
MMC 405 TRUNK CO TEL NUMBER
MMC 406 TRUNK RING ASSIGNMENT
MMC 407 FORCED TRUNK RELEASE
MMC 408 ASSIGN TRUNK MOH SOURCE
MMC 409 TRUNK STATUS READ
MMC 410 ASSIGN DISA TRUNK
MMC 411 ASSIGN E1 SIGNAL TYPE
To Next Page
Loading...
