Samsung OfficeServ 7000 Series - Page 184

CHAPTER 2. MMC Programming
2-146
© SAMSUNG Electronics Co., Ltd.
CONDITIONS
 Before setting the PRI program, the J2 jumper of the TEPRI or TEPRI2 card must be
set to ‘ON’ for PRI mode.
 After changing this program, run MMC 418, BRI AND PRI CARD RESTART, to
apply the new setting.
DEFAULT DATA
CHANNEL ANY: YES
PRI MODE: DDI
DLSEND: OVERLAP
CLIP TABLE: 1
NB TYPE: UNKNOWN
NB PLAN: ISDN
CLIR w NUMB: OFF
ECT SERVICE: OFF
EFWD REROUT: OFF
SAME CONNID: OFF
CD PLAN: UNKNOWN
CD TYPE: UNKNOWN
TIME SYNC: OFF
DIVERT: OFF
CENTREX: OFF
ACTION DISPLAY
1) Press Transfer button and enter 420.
Display shows:
[701] PRI OPTION
CHANNEL ANY:YES
2) Dial first PRI trunk number in PRI card. (e.g., 730)
OR
[730] PRI OPTION
CHANNEL ANY:YES
Press Volume button to make selection and press
Right Soft button.
3) Enter option number.
OR
[730] PRI OPTION
PRI MODE:DDI
Press Volume button to select option.
4) Press Volume button to make selection.
Then press Right Soft button.
[730] PRI OPTION
PRI MODE:NORMAL
5) Press Transfer button to save and exit.
OR
Press Speaker button to advance to next MMC.