Samsung OfficeServ 7000 Series - Page 234

CHAPTER 2. MMC Programming
2-196
© SAMSUNG Electronics Co., Ltd.
CONDITIONS
 A station can be assigned to all station groups. A station group can normally
accommodate up to 99 members, but only up to 32 members if the RING MODE is
UNCONDITIONAL.
 To enable off-hook ring for incoming calls to busy members, set OFFHOOK RING in
MMC 300, CUSTOMER ON/OFF PER STATION, to ON. Even in this case, however,
the off-hook ring is enabled only when the RING MODE is UNCONDITIONAL.
DEFAULT DATA
NORMAL GROUP
ACTION DISPLAY
1) Press Transfer button and enter 601.
Display shows:
[501] STN.GROUP
TYPE:NORMAL GRP
2) Dial group number. (e.g., 505)
OR
[505] STN.GROUP
TYPE:NORMAL GRP
Press Volume button to select group and Press Right
Soft button to move cursor.
3) Dial feature option number. (0-7, e.g., 0)
OR
[505] STN GROUP
TYPE:VMAA GROUP
Press Volume button to scroll options and press Right
Soft button to move cursor.
4) DIAL group type. (e.g., 1)
OR
[505] STN GROUP
TYPE:VMAA GROUP
Press Volume button to make selection and press Left
Soft button to move cursor to TYPE.
5) Dial feature option number. (0-6, e.g., 1)
OR
[505] STN GROUP
RING:DISTRIBUTE
Press Volume button to scroll options and press Right
Soft button to move cursor.
6) Dial ring option. (0-2, e.g., 0)
OR
[505] STN GROUP
RING:SEQUENTIAL
Press Volume button to make selection.
Press Left Soft button to move cursor back to RING
or press Right Soft button to return to step 2.