Samsung OfficeServ 7000 Series - Page 309

OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-271
(Continued)
Option Description Default
TRUNK FOR DN2 If set to yes, when the voice mail auto attendant system answers
a call the system will send data in the DN2 field indicating the
originating trunk of the call ringing the VMAA port.
If set to no, when the voice mail auto attendant system answers
a call the system will not send trunk data in the DN2 field.
No
SEPARATOR When both DN1 and DN2 are used, a digit defined here is sent
between DN1 and DN2 so the VMAA system can determine
where DN 1 stops and where DN 2 starts. The separator can be
DTMF 0 through 9, *, #, A, B or C.
No
DISCONNECT
SIGNAL
This is the call progress digit sent to the VMAA port in place of a
disconnect open. The digit defined here is sent three times.
C
CALL TYPE ID This is the DTMF digit that is sent first in the in band digit string
and can identify any of the following call types.
-
No
Call Type
Description
Default
0 DIRECT
CALL
A call originating directly from another
station in the system.
1
1 ALL FWD
CALL
This indicates that a call was forwarded to
the VM/AA port from a station with CALL
FORWARD ALL set.
2
2 BSY FWD
CALL
This indicates that a call was forwarded to
the VM/AA port from a station with CALL
FORWARD BUSY set.
3
3 NOA FWD
CALL
This indicates that a call was forwarded to
the VM/AA port from a station with CALL
FORWARD NO ANSWER set.
4
4 RECALL A call is recalling the VM/AA port after
being transferred and not answered.
4
5 DIR TRK
CALL
A Trunk Line call has gone directly to
VM/AA. (e.g., trunk 717 DIL to VM/AA)
6
6 OVERFLOW A call has OVERFLOWED to the VM/AA
port from a station group.
4
7 DID CALL A DID call has called the VM/AA port. 8
8 MESSAGE
CALL
A message button or message reply
feature code has been used to call the
VM/AA port.
9