Samsung OfficeServ 7000 Series - Page 433

OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-395
(Continued)
No Option Description Default
04 CTI LINK OPTION Sets CTI link via LAN option with the system. -
0 SMDR REPORT: Sets YES or NO for SMDR data
to CTI link via LAN.
NO
1 UCD REPORT: Sets YES or NO for UCD data to
CTI link via LAN.
NO
2 ALIVE: This is a CTI link via LAN alive check
timer. If this is set to 0, the system will not
check link alive.
300 SEC
05 ITP DSP PARA Sets IP phone DSP parameter system wide. -
0 M-FRAME: This value determines the
transmission interval time of VoIP packets
generated by the IP phone. This data uses
DOWN = SYS DATA only (see 3, below).
The range is 10~40 ms.
20 ms
1 JITTER: Decides the minimum time to consider
delay for jitter adjustment. This data uses
DOWN = SYS DATA only (see 3, below).
The range is 10~90 ms.
20 ms
2 TOS/Dif: An 8-bit binary value that will be used
by external routers, switches, etc, (that
optionally support TOS-bit prioritization) to
identify the transport-priority value of data
packets generated by the IP phone. This value
can be left at the default value (00000) if your
network infrastructure does not support this
method of bandwidth management. This data
uses DOWN = SYSTEM DATA only (see 3,
below).
All bits 0
3 CONTROL: Designate whether to set the DSP
parameter of the IP phone as the SYSTEM
BASE or as the ITP BASE.
SYS BASE
4 CODEC: Designate whether to use the CODEC
based on the MGI or to use the CODEC of the
IP phone when connecting the call between the
IP phone and the MGI.
MGI FIRST
06 ITP TX GAIN/HSET Sets IP-based phone Handset TX gain value of
each level.
LEVEL 1: 25
LEVEL 2: 27
LEVEL 3: 29
LEVEL 4: 31
LEVEL 5: 33
LEVEL 6: 35
LEVEL 7: 37
LEVEL 8: 39