Appendix
A.3 Connecting cable
SIMATIC RF200
336 System Manual, 07/2015, J31069-D0227-U001-A9-7618
Connecting cable with angled connector
Figure A-16 Connecting cable between ASM 456, RF160C, RF170C, RF180C and RF2xxR reader
(RS-422) with angled connector
Table A- 13 Ordering data
10 m 6GT2891-4JN10
The angled connector has a height of h = 29 mm and a length of l = 38 mm. Remember that
due to the construction, the distance between the edge of the connector and the edge of the
reader housing (H) is higher.
Figure A-17 Distance between connector edge and housing edge
The distance between the edge of the connector and the edge of the reader housing (H) is
as follows: RF210R/RF220R = 33 mm, RF240R/RF260R = 36 mm and RF290R = 37 mm. If
you look at the reader from below, the angled connector points 90° to the right. With the
RF290R reader the angle is approximately 135°.
To Next Page
Loading...
