STONEX R2 - Main Settings

STONEX R2
48
②Press [F3] to delete the last record,
as shown on the right.
[F3]
Sure delete final record?
CANCEL OK
③Press [F4] to confirm the deleting.
If not, press [F1] (CANCEL), the
program will return to Measure
function.
【Measure】
P + ID： A2
R.HT： 1.500 m
HZ： 0°00′00″
V： 90°10′50″
： ---.--- m Ⅰ
： ---.--- m
All DIST RECORD ↓
4.4 MAIN SETTINGS
This menu enables extensive user-specific settings in order to adapt the instrument to their
own requirements.
You can rewrite some important settings.
You can also start this function by selecting “Settings” in “Menu”.
OPERATION STEPS：
OPERATIONAL STEPS
OPERATION
DISPLY
① Press [FNC] to enter into the
Function menu and select “Main
Settings”, or press [MENU] and select
“Settings”.
FNC
【Function】1/4 ▼
F1 Level (1)
F2 Target Offset (2)
F3 Delete Last Record (3)
F4 Main Settings (4)
② Press [F4] to enter into Settings
function.
[F4]
【Setting】1/4 ▼
Contrast： 4
TriggerKey: OFF
User Key: Light
V-Setting: Zenith
Tilt Crn： OFF
Coll. Crn: OFF
SET