2
INSIGHT Software
System Settings
Thermo Scientific Evolution 200 Series User Guide 99
System Settings
Alignment Tab
Calibrations Tab
Lamp Tab
System Tab
Diagnostics tab
Alignment Tab
Use the Alignment tab in System Settings to view sample and reference detector intensities
while aligning an accessory.
Y To perform an alignment
1. To measure intensities using a green light (510 nm), select Green. To use no filter, select
White.
The correct setting depends on the installed accessory. See Accessories.
2. Set Bandwidth as desired.
The available settings depend on the instrument.
3. Click Start.
Every half second the sample and reference detector intensities are plotted and displayed
by the Sample beam and Reference readouts.
These are available in System Settings:
Note The Diagnostics tab is for our use only.
To Next Page
Loading...
