20
Peltier Thermostatted Single Cell Holder
Thermo Scientific Evolution 200 Series User Guide 317
Verifying the Power Supply and Fuse
For operation at 120 V, configure the voltage selector on the Peltier back panel and insert the
correct fuse as described in the following table.
Adjustment for frequency change between 50 and 60 Hz is not necessary.
Related Topics
Changing the Voltage Setting or Fuse
General Safety Information
Preinstallation
Installation
Operation
Maintenance
Troubleshooting
• Verifying the Power Supply and Fuse
• Changing the Voltage Setting or Fuse
NOTICE The unit is factory set to operate at 220 V.
Power Supply Type of fuse - 250 V
240 V T 1A, Slo Blo
120 V T 2A, Slo Blo
Voltage display window
Fuse drawer tab
To Next Page
Loading...
