Thermo Scientific Evolution 201 - Performing a Kinetics Measurement

2
INSIGHT Software
Operation
Thermo Scientific Evolution 200 Series User Guide 31
To measure a sample again, right-click its row in the results table and choose Remeasure.
After the remeasurement, the previous information for the sample is crossed out (but not
removed from the table).
To copy the data on the Standard Curve(s) tab or Run Chart tab, right-click the plot and
choose Copy to Clipboard.
Related Topics
Quantifying Samples Without Using Standards
Performing a Quantitative Analysis
Data Display
Quant
Formulas and Units Tab
Performing a Kinetics Measurement
Click Rate in the right pane in Home to set up and
perform a kinetics measurement. The tasks buttons below
become available.
To set Rate parameters, click Settings.
To access features for performing the measurement,
click Measure Rate.