Toro TX525 - Page 309

HYDRAULIC SYSTEM
6-46 Rev. 000 TX525 Service Manual
4. Mark the large pump bushing assembly with a “V” all
the way down onto the pump shaft cover (Fig. 1004).
2. Remove the o-ring from the housing (Fig. 1002).
Fig 1004 PICT-2840
Fig 1002 PICT-2882a
5. Remove the large pump bushing assembly from the
pump shaft cover (Fig. 1005).
3. Remove the drive link from the drive gear (Fig.
1003).
Fig 1005 PICT-2841a
Fig 1003 PICT-2839a