Toro TX525 - Page 350

HYDRAULIC SYSTEM
6-87TX525 Service Manual Rev. 000
15. Position the pivot onto the base plate and install the
2 screws, using a 3mm Allen wrench, to secure the
pivot to the base plate. Torque the 2 screws to 7 ft-
lbs. (9.5 Nm) (Fig. 1163).
17. Position the loader lift joystick joint into the lift spool
and install the nut. Torque the nut to 31 ft-lbs. (42
Nm) (Fig. 1165).
Fig 1163 PICT-2646
Fig 1165 PICT-2649a
18. Apply thread locking compound to the threads of the
pivot joystick joint (Fig. 1166).
16. Apply thread locking compound to the threads of the
loader lift joystick joint (Fig. 1164).
Fig 1164 PICT-2648a
Fig 1166 PICT-2650a