Toro TX525 - Page 403

DRIVE SYSTEM
7-26 Rev. 000 TX525 Service Manual
27. Raise the hood.
28. Remove the hairpin cotter from the hood prop rod
(Fig. 1356).
Fig 1356 Belt 001
29. Support the hood and remove the prop rod (Fig.
1357).
31. Using a 3/16” Allen wrench, remove the 2 upper heat
shield screws (Fig. 1359).
Fig 1357 Belt 003
Fig 1359 Belt 004
30. Using a 1/2” wrench, remove the 2 lower heat shield
screws (Fig. 1358).
Fig 1358 Belt 002