Adjustments and Calibrations 6-5
Restore Factory Settings (Margins)
You can reset margin settings to the factory-default values.
Caution
Use caution when resetting your margins to the factory-default settings.
Changing these settings back to factory defaults may not be the last-saved
settings if you have previously calibrated your margins.
1. From the Main Menu, highlight Troubleshooting and press OK.
2. Highlight Print Quality Problems and press OK.
3. Highlight Calibrate Margins Menu and press OK.
4. Highlight Restore Factory Settings and press OK to reset the margin settings.
Resetting Connection Setup Defaults
Resetting the Connection Setup values sets TCP/IP address, TCP/IP address menu
settings (gateway, broadcast, etc.), CentreWare IS, EtherTalk, Netware, set IPX frame
type, IPP, Ethernet speed, Wait Timeout, Page Description Language, and Port
selection for both Parallel and USB Ports to their default values.
Caution
Make note of the current network settings or print a configuration page to provide
a record of the customer’s current network settings before resetting the
connection setup to the factory default values.
1. From the Main Menu, highlight Printer Setup and press OK.
2. Highlight Connection Setup and press OK.
3. Highlight Reset Connection Setup and press OK to reset connection defaults.
Resetting Paper Handling Defaults
Resetting the Paper Handling defaults resets the paper source, 2-sided printing, tray
setup, load paper timeout, tray sequence, custom units and jam recovery settings to
their default values.
1. From the Main Menu, highlight Printer Setup and press OK.
2. Highlight Paper Handling Setup and press OK.
3. Highlight Reset Paper Handling Setup and press OK.
4. Highlight Reset Paper Handling Setup NOW and press OK to reset the paper
handling defaults.
To Next Page
Loading...
Need help?
General