Service Parts Disassembly 8-49
14. Remove the e-rings (item #1) from the right and left Shaft Pivots securing the
bottom of the Chute Assembly Out to the printer.
15. Open Door B and press on the solenoid latch-plate on the left side to release the
lower plate assembly. Ensure that the lower plate assembly raises up.
Caution
The plate assembly bottom may have sharp burrs, be careful when
performing the following Steps.
16. Using needle nose pliers, remove the left and right Shaft Pivots (item #2), pulling
them inward to remove.
Caution
Remove the Chute Assembly Out slowly and carefully ensuring that the
wiring harnesses do not catch and sustain damage during removal.
17. Release the latch at Door B and pull the Chute Assembly Out forward to remove.
6250-176
1
2
1
To Next Page
Loading...
