Xerox PHASER 6250 - Page 95

Error Messages and Codes 3-13
Tray 2 Low
Paper
Tray 3 Low
Paper
Tray 4 Low
Paper
Size: XXXX
Paper is Not Low
Paper is Low
Move the Rear Guide in the paper
tray to the desired paper size and
verify the sensor output matches
the paper size selected.
Insert and fill Tray [2] [3] [4] with
paper to the fill line.
Insert one sheet of paper in Tray
[2] [3] [4] to change the sensor
state.
Tray 1 (MPT)
No Paper
Sensor
Paper is Not Present
Paper is Present
Insert Paper into Tray 1. Toggle the
Tray 1 No Paper Actuator
(PL6.1.37) to change the state.
Tray 2 No
Paper Sensor
Tray 3 No
Paper Sensor
Tray 4 No
Paper Sensor
Paper is Not Present
Paper is Present
Insert Tray [2] [3] [4] with an
adequate amount of paper.
Toggle the No Paper Actuator.
Transfer Roll
Toner Full
Sensor
Toner Waste [Not] Full Block the Toner Full Sensor
(PL5.1.13) to change the sensor
state.
Image Unit Not
Installed
Sensor
Image Unit is [Not] Present Open Door C to change the state
of the Switch.
Fuser Fan
Alarm Sensor
Fuser Fan Alarm Sensor is: OK
Failure
Status only
Note: Perform a test print
immediately prior to performing
this test.
Rear Fan
Alarm Sensor
Rear Fan Alarm Sensor is:
OK
Failure
Status only
Note: Perform a test print
immediately prior to performing
this test.
CTD (ADC)
Sensor
Dark Value: #
Light Value: ###
Sensor OK
Status only
Remove the transfer roller to
observe change of state.
Test Front Panel Display and Test Definition