Agilent Technologies U2000 Series

CALCulate Subsystem 3
U2000 Series Programming Guide 89
CALCulate[1]:LIMit Commands
These commands set the limits on the current window/measurement enabling
you to:
• Set upper and lower level limits
• Query if there has been a failure
• Count the number of failures
• Clear the counter
The following commands are detailed in this section:
CALCulate[1]:LIMit:CLEar:AUTo <boolean>
CALCulate[1]:LIMit:CLEar[IMMediate]
CALCulate[1]:LIMit:FAIL?
CALCulate[1]:LIMit:FCOunt?
CALCulate[1]:LIMit:LOWer[:DATA]
CALCulate[1]:LIMit:UPPer[:DATA]
CALCulate[1]:LIMit:STATe <boolean>