MEASurement Commands 2
U2000 Series Programming Guide 77
READ[1] Commands
The READ? commands are most commonly used with the CONFigure
command to cause a new power measurement to be taken and the result
returned to the output buffer. The format of the result is set by
FORM[:READ][:DATA]. Refer to Chapter 5, “FORMat Subsystem,” on page 119
for further information.
•The READ? query is equivalent to:
ABORt
INITiate
FETCh?
or
ABORt1
INITiate1
FETCh1?
To Next Page
Loading...
