Agilent Technologies U2000 Series

7SENSe Subsystem
174 U2000 Series Programming Guide
SENSe[1]:CORRection:CSET[2][:SELect] <string>
This command enters the name of the sensor frequency dependent offset table
which is to be used.
Syntax
Parameters
NOTE
If SENSe[1]:CORRection:CSET2:STATe is set to OFF, the selected sensor frequency
offset table is not being used.
Item Description/Default Range of Values
string String data representing a sensor
frequency dependent offset table name.
Any existing table name
(Existing table names
can be listed using
MEMory:CATalog:TABle?).
SENS
1
:CSET2
CORR
:
?
:SEL
string
Space
1