6MEMory Subsystem
126 U2000 Series Programming Guide
MEMory Subsystem
The MEMory command subsystem is used to:
• Edit and review sensor frequency dependent offset tables.
• Store sensor frequency dependent offset tables.
• Edit and review sensor save/recall registers.
Stored tables remain in the power sensor’s memory during power down. The
power sensor is capable of storing 10 frequency dependent offset tables of 80
frequency points each.
Keyword Parameter Form Notes Page
MEMory
:CATalog
[:ALL]? [query only] page 129
:STATe? [query only] page 131
:TABLe? [query only] page 132
:CLEar
[:NAME] <character_data> [no query],
[non-SCPI]
page 135
:TABLe [no query] page 137
:FREE
[:ALL]? [query only] page 139
:STATe? [query only] page 140
:TABLe? [query only] page 141
:NSTates? [query only] page 142
:STATe
:CATalog? [query only] page 144
:DEFine <character_data>
[,<numeric_value>]
[non-SCPI] page 145
:TABLe
:FREQuency <numeric_value>
[,<numeric_value>]
page 148
:POINts? [query only] page 151
To Next Page
Loading...
Need help?
General
