Agilent Technologies U2000 Series

SERVice Subsystem 8
U2000 Series Programming Guide 218
SERVice:SENSor[1]:TNUMber <“tracking_number”>
This command is used to enter the tracking number of U2000 Series USB
power sensors.
Syntax
Example
Query
SERVice:SENSor[1]:TNUMber?
This query returns the tracking number for U2000 Series USB power sensors.
Tracking number information is stored in the sensor’s non- volatile memory.
Query Example
SERV:SENS1:TNUM
“PEN12345”
This command enters the tracking
number of PEN12345.
SERV
1
:TNUM
:SENS
“tracking_number”
?
Space
SERV:SENS1:TNUM? This query returns the tracking number of
the U2000 Series USB Power Sensor.
NOTE
If tracking number is not pre-programmed, “NONE” string is returned.