3CALCulate Subsystem
90 U2000 Series Programming Guide
CALCulate[1]:LIMit:CLEar:AUTo <boolean>|ONCE
This command controls when the FCO (fail counter) is cleared of any limit
failures. The FCO is used to determine the results returned by the
CALCulate[1]:LIMit:FAIL? query.
•If ON is specified, the FCO is set to 0 each time a measurement is:
• Initiated using INITiate[:IMMediate]
• Initiated using INITiate:CONTinuous ON
• Measured using MEASure?
• Read using READ?
•If OFF is specified, the FCO is not cleared by the above commands.
•If ONCE is specified, the FCO is cleared only after the first initialization
then starts accumulating any limit failures.
SyntaxExample
Reset Condition
On reset, measurement is set to ON.
CALC1:LIM:CLE:AUTO 1 This command switches on automatic
clearing of the FCO for the current
window/measurement.
To Next Page
Loading...
Need help?
General
