Agilent Technologies U2000 Series

8SERVice Subsystem
217 U2000 Series Programming Guide
SERVice:SENSor[1]:SNUMber <“serial_number”>
This command is used to enter the serial number of U2000 Series USB power
sensors.
Syntax
Example
Query
SERVice:SENSor[1]:SNUMber?
This query returns the serial number for U2000 Series USB power sensors.
Serial number information is stored in the sensor’s non- volatile memory.
Query Example
SERV:SENS1:SNUM MY12345678 This command enters the serial number
and the changes of serial number will
take effect after power recycle.
SERV
1
:SNUM
:SENS
“serial_number”
?
Space
SERV:SENS1:SNUM? This query returns the serial number of
the U2000 Series USB Power Sensor.