13 IEEE 488.2 Command Reference
296 U2000 Series Programming Guide
SCPI Compliance Information
This chapter contains information about the SCPI Common (*) Commands
that the power sensor supports. It also describes the USBTMC/USB488
Universal Command statements which form the nucleus of USB programming;
they are understood by all instruments in the network. When combined with
programming language codes, they provide all management and data
communication instructions for the system.
The IEEE- 488.2 Common Command descriptions are listed below in
alphabetical order.
*CLS Clear Status page 297
*ESE and *ESE? Event Status Enable page 298
*ESR? Event Status Register page 300
*IDN? Identify page 301
*OPC and *OPC? Operation Complete page 302
*OPT? Options page 303
*RCL Recall page 304
*RST Reset page 305
*SAV Save page 306
*SRE and *SRE? Service Request Enable page 307
*STB? Status Byte page 309
*TRG Trigger page 311
*TST? Te s t page 312
*WAI Wait page 313
To Next Page
Loading...
Need help?
General
