11 TRIGger Subsystem
264 U2000 Series Programming Guide
INITiate Commands
Initiate commands allow you to place the power sensor in the wait for trigger
state.
The INITiate commands are overlapped, that is, the power sensor can
continue parsing and executing subsequent commands while initiated. Note
that the pending operation flag is set, when the power sensor enters an idle
state and the flag is cleared when it re- enters the idle state.
The following commands are described in this section:
INITiate[1]:CONTinuous <boolean>
INITiate[1][:IMMediate]
INITiate:CONTinuous:ALL <boolean>
INITiate:CONTinuous:SEQuence[1] <boolean>
INITiate[:IMMediate]:ALL
INITiate[:IMMediate]:SEQuence[1]
To Next Page
Loading...
Need help?
General
