7SENSe Subsystem
176 U2000 Series Programming Guide
SENSe[1]:CORRection:CSET[2]:STATe <boolean>
This command is to enable and disable the use of the currently active sensor
frequency dependent offset table (CSET2). When a table has been selected and
enabled, the sensor frequency dependent offsets stored in it can be used by
specifying the required frequency using the SENSe[1]:FREQuency command.
When the CSET2 command is set to ON, the frequency dependent offset is taken
from the sensor frequency dependent offset table and is used.
Syntax
Example
Reset Condition
On reset, the sensor frequency dependent offset table are not affected.
Query
SENSe[1]:CORRection:CSET[2]:STATe?
The query returns a 1 or 0 into the output buffer indicating whether a table is
CORR:CSET2:STAT 1 This command enables the use of the
currently active sensor frequency
dependent offset table for power sensor.
To Next Page
Loading...
Need help?
General
